Puffco Peak Pro Link – Peak Pro technology for your own glass bong
With the Puffco Peak Pro Link, you connect the electronics of your Puffco Peak Pro to a glass rig you already own. The Link holds the 3D or 3DXL chamber and fits into the glass where the banger would normally sit; the Peak Pro base supplies the heat via a cable. Peak Pro and chamber are not included.
Electronic heat instead of a torch and timer
A traditional banger is heated with a torch and cools as soon as you take a draw—the first draw tastes different from the last, and you can only get the timing right with a timer or temperature gun. The Link instead brings the Peak Pro’s real-time temperature control to your rig. You use the same heat profiles as on the device, including settings from the Puffco Connect App. No torch, butane, or temperature gun needed.
Sleeves for 10 mm and 14 mm joints
To make the Link fit as many rigs as possible, adapter sleeves for 10 mm and 14 mm are included. The cable is about 76 cm (30 inches) long, so the base can sit beside the rig. There’s a stand to safely set the Link down between draws. Two replacement O-rings and a cable clip to keep things tidy complete the set.
Your glass filters, the Peak Pro heats
The Link isn’t a second device, but a bridge between two you already own. Your own glass still handles cooling and filtration, including its percolator and draw. If you have a favorite piece sitting unused since switching to an e-rig, this brings it back to the table. Any Peak Pro works as a base, such as the Puffco Peak Pro 3DXL.
Important: Check the firmware first
For the Peak Pro to recognize the Link, it needs up-to-date firmware; according to the distributor, version “AW” or later. Update older devices through the Puffco Connect app before first use. Puffco provides a one-year warranty on the Link itself.
Our practical tip
Before inserting it, check the joint size of your rig and choose the matching sleeve. Route the cable with the clip so it doesn’t pull on the glass. After each draw, place the Link on the stand so the hot chamber doesn’t rest against anything.
Conclusion
The Puffco Peak Pro Link brings Peak Pro temperature control to your own glass rig – without a torch and with repeatable draws. For Peak Pro owners who already have a glass bong, it’s a direct way to connect the two.
Scope of delivery
- 1 x Puffco Peak Pro Link
- 1 x stand
- 1 x 10 mm adapter sleeve
- 1 x 14 mm adapter sleeve
- 2 x O-rings
- 1 x cable clip
Note: Peak Pro, chamber, and glass rig are not included.
Manufacturer
Manufacturer: Puffco, 1201 W 5th St, Los Angeles, CA 90017, USA, https://www.puffco.com/pages/contact , support@puffco.com
Importer / distributor: Reinhart GmbH & Co.KG, Tempelhofer Straße 21, 52068 Aachen, Germany, https://reinh.art/, info@reinhart.shop

